Scan and sync to an open frequency:

1. On the URX-S03D slot-in receiver, open the full screen menu on the channel you want to scan for: tap the MENU button once for channel 1, press it a second time for channel 2. The selected channel is indicated by RX1 or RX2 in the top-left of the screen.


2. Once on the desired channel, tap "–" (bottom right button) once to see AUTO SET.


• To sync a device without rescanning, such as when setting two transmitters to the same channel, continue pressing "–" until the display reads SYNC, then continue with the following steps.


3. Hold the SET button for about a second until YES appears on the display. Tap SET one more time and the channel scan will begin. This may take up to 20 seconds.


4. Once a channel is found, the receiver display will read SYNC and show an arrow pointing right toward the IR sensor.


5. Hold the transmitter's IR sensor up to the receiver and you'll see the transmitter's screen illuminate and display SYNC, NO


6. Press down on the transmitter to see SYNC, YES then hit SET. This must be done within 10 seconds or the option will time out.

Your wireless gear should now be synced.

OTHER CONSIDERATIONS

Set the receiver to frequency group "00"

For the AUTO SET function to scan all 188 frequencies within the receiver's range and find the clearest channel available, the receiver must be set to frequency group "00", as indicated by the first two digits on the display.

To set the frequency group:

1. On the URX-S03D slot-in receiver, open the full screen menu on the channel you wish to adjust: tap the MENU button once for channel 1, press it a second time for channel 2.


2. Hold The SET button until the group indicator starts blinking.


3. Press "–" until the group indicator reads "00".


4. Press SET twice to save the setting.


5. Perform an AUTO SET as described above.

Attachments:
URX-S03D_manual_(extract).pdf


 
Was this article helpful? yes / no